12
4.2- Electric fitting: Machine with motor
The electric wire (1) must be connected to the circuit
breaker or fuse box before to switch it to the plug.
See the guidances below:
NOTE: JF 2D can be equipped with 2 or 3 hp (IP 21, IP
55). The motor leaves the factory set up to operate in
220 volts, according the label (2) attached to the cord.
If your network to become 110 volts, the electrician
must changes the electric motor wiring, according to
the motor nameplate.
Attention:
Contract a good electrician to perform
the electric fitting, in order to assure the
safety and equipment correct operation.
1
2
To Next Page
Loading...
