30
7.8- Machine conservation
Remove all product waste that remained inside the machine.
Always if necessary, wash the machine and let it dry at the sun.
Check the bolts tightener of the impeller knifes.
Remake painting in the points where needed.
Lubricate the bearings of the impeller.
Very important: Always keep the machine in a dry place, protected from sun and rain.
Without this care, there is no preservation.
Protect the machine against bad weather and the corrosive effect of some products.
After the use, adopt the cares below:
8- Stickers found on the head
To Next Page
Loading...
