John Bean VPI SYSTEM III - Table of Contents

Page 3
John Bean VPI System III Operators Manual
TABLE OF CONTENTS
General Safety Instructions Page 2
1.0 Introduction Page 4
1.1 Safety Notice Page 4
1.2 Balancer Application Page 4
1.3 Specifications Page 5
1.4 Balancer Features Page 5
1.5 Standard Accessories Page 6
1.6 Optional Accessories Page 6
1.7 Dimensions Of The Machine Page 7
1.8 Installation Area Page 7
2.0 Installation Instructions Page 7
2.1 Component Installation Page 7
2.2 Hood Guard Installation Page 8
2.3 Width SAPE Arm Installation Page 8
2.4 Electrical Installation Page 8
3.0 Terminology Page 9
4.0 Balancer Operation Page 10
4.1 Inspection Check list Page 10
4.2 Wheel Mounting Page 10
4.2.1 Mounting of Standard Wheels Page 10
4.2.2 Using the Power Clamp Option Page 11
4.2.3 Mounting of Light Truck Wheels Page 12
4.3 Mode Selection Page 12
4.3.1 Weight Placement Modes Page 12
4.4 Selecting Operator Preferences Page 13
4.4.1 Fine Balance Mode Page 13
4.4.2 Ounce /Grams Conversion Page 13
4.4.3 Inch/Millimeter Conversion Page 13
4.4.4 Selection of Operator A/B Page 13
4.4.5 Operation of Weight Miser™ Page 13
4.5 Entering Rim Parameters Page 15
4.5.1 Distance and Diameter Entry Page 15
4.5.2 Rim Width Entry Page 15
4.5.3 Manual Parameter Entry Page 15
4.6 Correcting the Imbalance Page 16
4.7 Verifying Results Page 16
4.8 Vibration Problems Page 16
5.0 Matching Program Page 17
6.0 Optimization Program Page 19
7.0 Alu-S 2 Plane Program Page 20
7.1 Alu-S Single - Plane Program Page 21
8.0 Spoke Mode Page 22
9.0 Split Weight Mode Page 23
10.0 User Shaft Calibration Page 24
11.0 Width SAPE Calibration Page 25
11.0 Full SAPE Calibration - Width, Distance and Diameter Page 25
12.0 Maintenance/Troubleshooting and "F" Codes Page 27
13.0 Maintenance Page 26
14.0 Trouble Shooting Page 25