In complying with Johnson Controls policy for continuous
product improvement, the information contained in this docu-
ment is subject to change without notice. While Johnson
Controls-Frick makes no commitment to update or provide
current information automatically to the manual owner, that
information, if applicable, can be obtained by contacting the
nearest Frick Factor or the nearest Frick Sales ofce.
It is the responsibility of operating/service personnel to verify
the applicability of these documents to the equipment in
question. If there is any question in the mind of operating/
service personnel as to the applicability of these documents,
then prior to working on the equipment, they should verify
with the owner whether the equipment has been modied
and if current literature is available.
This equipment is a relatively complicated apparatus. During
installation, operation, maintenance or service, individuals may
be exposed to certain components or conditions including,
but not limited to: refrigerants, oils, materials under pressure,
rotating components, and both high and low voltage. Each
of these items has the potential, if misused or handled
improperly, to cause bodily injury or death. It is the obligation
and responsibility of operating/service personnel to identify
and recognize these inherent hazards, protect themselves,
and proceed safely in completing their tasks. Failure to comply
with any of these requirements could result in serious damage
to the equipment and the property in which it is situated, as
well as severe personal injury or death to themselves and
people at the site.
This document is intended for use by owner-authorized
operating/service personnel. It is expected that this indi-
vidual possesses independent training that will enable them to
perform their assigned tasks properly and safely. It is essential
that, prior to performing any task on this equipment, this
individual shall have read and understood this document and
any referenced materials. This individual shall also be familiar
with and comply with all applicable governmental standards
and regulations pertaining to the task in question.
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION
DANGER
NOTICE
WARNING
To Next Page
Loading...
Need help?
General
