Upon completion of start-up the customer assumes responsibility for periodic maintenance of this equipment in order to continue
warranty. Refer to the Installation Operation and Maintenance Manual provided with this equipment.
_______________________________________ , _________________
Unit Nameplate V___ PH___ CYC, ____ Verify V __________ / ___________/ ____________
SUPPLY FAN MOTOR RETURN FAN MOTOR
Nameplate Volts ___________ Amps _______________ Volts ______________ Amps ____________
Run Amps ___________/ ___________ / ___________ ___________ / ___________ / ____________
Catalog Number _____________________________________ ______________________________________
Spec Number _____________________________________ ______________________________________
Horse Power _____________________________________ ______________________________________
RPM Nameplate ______ ___ Actual____________ Nameplate __________ Actual ___________
Frame size _____________________________________ ______________________________________
Service Factor _____________________________________ ______________________________________
Jump (Skip) Frequencies ___________/ ___________ / ___________ ___________ / ___________ / ____________
SUPPLY FAN DRIVE KIT RETURN FAN DRIVE KIT
Belts (Quantity & ID Number) _____________________________________ ______________________________________
Belt Tension Tag________________ Actual ___________ Tag________________ Actual ____________
Fan RPM (DN) Tag________________ Actual ___________ Tag________________ Actual ____________
Refrigerant Number: _______________
Refrigerant Liquid Supply: ________________ psig ________________ °F
Rrefrigerant Gas Suction: ________________ psig ________________ °F
Gas Supply Pressure ________________ psig Natural Gas or Propane (Circle one)
________________ "Hg
Steam Pressure ________________ psig
SUPPLY FAN RETURN FAN
Manufacture Name _____________________________________ ______________________________________
Type or Model Number _____________________________________ ______________________________________
Code or Shop Order Number ___________________________________ ______________________________________
Serial Number _____________________________________ ______________________________________
Refer to safety standards Ensure all door latches are secured before starting.
1. Energize power to the unit disconnect switch.
2. Verify correct voltage, phase and cycles.
3. Energize fan motor(s) briey (bump) and check
for correct fan rotation.
4. Check operation of dampers.
5. Energize fan motor(s). Observe fan(s) for
smooth operation.
6. Note/record motor nameplate Full Load Amp rating.
7.
Immediately verify current draw of each leg of each motor.
8. VFD, refer to manufactures start up guide.
9. Inspect doors and latches for air leaks.
10. Inspect
for obvious audible leaks.
11.
Apply steam to cold coils slowly to prevent damage.
To Next Page
Loading...
