Johnson Controls Penn System 450 Series Installation Instructions

System 450™ Series Control Module with Ethernet Communications Installation Instructions36
Analog Output Configuration Page
Figure 11 shows an example Analog Output
Configuration Page for a System 450 control system
that is set up and operating.
Table 16 provides descriptions, user actions, and
references for the items called out in Figure 11.
Table 16: System 450 Web UI Analog Output Configuration Page, User Actions, Descriptions, and
References (Part 1 of 3)
Callout
Number
Identifier / Item
Name
User Actions, Descriptions, References
1 Logout and
Configuration
Buttons
See System Configuration Page
on page 31 for descriptions and user actions regarding the
System, Sensor, and Network buttons.
2Site NameDisplays the assigned site name. You can assign a website name on the Network
Configuration page.
See Network Configuration Page
on page 41 for more information about assigning a site
name.
3Output
Configuration:
OUTA-2
Displays the output type (OUTA or OUTR) and output number (-n), which are assigned by
the control module.
Note: When you first power on a System 450 module assembly, the control module
automatically detects the connected outputs and assigns an output type and
number for each connected output.
In this example, an analog output is detected and identified in the number 2 position in the
module assembly (OUTA-2).
Figure 11: System 450 Analog Output Configuration Page Example

Johnson Controls Penn System 450 Series Specifications

General

Brand	Johnson Controls
Model	Penn System 450 Series
Category	Control Systems
Language	English