ZFR1800 Series Wireless Field Bus System Technical Bulletin36
b. In CCT 10.0 and earlier, use Tools> Controller Information to ensure that
the radio firmware on each ZFR1811 Router and the boot firmware and
main firmware on each associated field controller is at the same version on
each WEFC in the mesh network. Note the devices that are not compliant;
this information is required in Step 4. This is no longer a requirement at
CCT 10.1, WEFC firmware version 6.2, and above.
Note: The ZFR1811 router Radio Firmware updates with the main code
download. Ensure that the ZFR1811 router is connected to the
associated controller during the main code download so that the radio
firmware updates.
c. Remember that the MS/TP trunk can support a mix of wireless controller
and wired controller versions.
d. Ensure that the ZFR1810 Coordinator version is equal to or higher than the
version of each WEFC.
e. Ensure that the Supervisory Controller (NxE) version is equal to or higher
than the ZFR1810 Coordinator version in order to take advantage of all
features in a controller.
For more information on CCT, refer to the Controller Tool Help (LIT-
12011147). For information on uploading or downloading devices firmware,
refer to the Loading Devices chapter of the Controller Tool Help
(LIT-12011147).
To Next Page
Loading...
Need help?
General
