3-189
The following screen is displayed in updating.
Confirm that the package version is uploaded in Watcher application. Confirm behavior.
Note
Do not power off, until the update is finished.
After started Watcher and NeCST application automatically, it takes a few minutes to use
again by ready to be preparing data processing.
Don’t power off until confirming that NeCST and Watcher application is able to be used.
When power off in updating, it may occur that application does not start.
If the NeCST application or the Watcher application does not start up automatically, the update may
be unsuccessful.
Confirm the package version by starting Watcher application manually.
Memo
If the version is not updated to the latest, update again.
If the Update button of the Watcher application is not valid even though the update is not
completed, update it again after rolling back.
For details on how to roll back, see 3.23.2 Performing software rollback.
If the Watcher application stops functioning properly or if the update fails many times,
contact the service request department.
To Next Page
Loading...