3-192
Confirm that the package version is uploaded in Watcher application.
Confirm behavior.
Note
Do not power off, until the rollback is finished.
After started Watcher and NeCST application automatically, it takes a few minutes to use
again by ready to be preparing data processing.
Don’t power off until confirming that NeCST and Watcher application is able to be used.
When power off in rollback, it may occur that application does not start.
If the NeCST application or the Watcher application does not start up automatically, the rollback
may be unsuccessful.
Confirm the package version by starting Watcher application manually.
Memo
Check the version and repeat the update or rollback as necessary.
If the Watcher application stops functioning properly or if the update fails many times,
contact the service request department.
Memo
[The procedure of manual roll-back]
Execute both Display Processing Unit and Data Processing Unit.
1. Open following folder.
C:\JRC\NeCST\Common
2. Execute of managing Rollback.bat.
Command Prompt screen is displayed and the rollback process starts.
After the rollback processing is completed, the command prompt screen is automatically
closed.
To Next Page
Loading...