Chapter 4 ADJUST MENU SETTINGS
4.11 MAINTENANCE
4-75
4
NSTALLATION MANUAL
When "Yes" is selected, the scanner time stored in the scanner internal control circuit
is transferred to the display unit to be stored.
Target scanner
NKE-2103
Display Unit to Scanner
Restores the scanner time data stored in the display unit into the scanner internal control
circuit.
When replacing the scanner internal control circuit, perform the procedure below to
inherit scanner time data.
1. Save the scanner time data.
2. Replace the scanner internal control circuit
3. Restore the scanner time data.
1 Open Maintenance - Display Unit to Scanner .
Yes : Transfers the scanner time data to the scanner internal control
circuit.
No : Does not transfer.
When "Yes" is selected, the scanner time saved in the display unit is transferred to
the scanner internal control circuit to be restored.
Target scanner
NKE-2103
To Next Page
Loading...
