JRC JMA-3404 - Nke-2103-4;6 Scanner (4 Feet;6 Feet)

Chapter 1 INSTALLATION
3
4
1.4.4 NKE-2103-4/6 SCANNER (4 FEET/6 FEET)
• NKE-2103
1. Put t he cab le into ca ble gl and wash ers a nd gas ket.
Tear the tape.
7- ::f JL-~'7 ·:~~ ~- 7f A-7 •:~ 1-, ?"7/t-:'t :: JM L,
7-- :t ~li J tJ<t u
2. Un knit sh iel d ne t and wra p it aro und a wa she r.
~-J v t-='.:t- ·:~ 1-~ta:c~ , '7 ·:~ ~~ t ::t!~Nit.Q o
3. Equip the scanner unit with brass-washers: appended .
brass-
washers
·~~'7·:~y~
tear a wa y c abl e sheath
1Jl5~"Jf.l < t washer
'7 ·:~ ~~
gas ke t
:ffA. 7 · :~1-
s hi eldnet
~- Jvt-:':.t-·:~1-
cab le gla nd
?"7/t-:'
c able sheath
f]lfl
4. Cut the shield ribbon and the vinyl covering from current position to 50mm lower part
and then put the copper tape again.
ll!ti¥G')fti. ii :IJ'~50mmY-Jvt-!
1
Jif./l:t::.=.- JLdJJ\-~~JL ''"C~IJTL, ~7--:f~I!6L)i[L -c<t:~L 'o
to connector
::J;:t-?~"'-
copper tape
m:r-:t
shieldribbon
y-J[,I'!IJi'f-/
vinyl coveri ng
t:.=.-jlt;I:JJ~-
to connector
:::J.:t·?~"'-
copper tape
llT- :1
vinyl coverin g
t:.=.-J(.,:fJJ~-
to connector
:::J;:t-?~"'-
vi nyl cove ri ng
t:.=.-J(.,:fJJ~-
copper tape
~7- :t
shie l dribbon
y-JL-1-!•Jif./