3－100
JMA-9172-SA Instruction Manual > 3.BASIC OPERATION > 3.8 APPLIED OPERATIONS
3.8.4 Set Cursor (Cursor Setting)
This function enables the setting of detail information about cursor operation and
display.
1) Open the Cursor Setting menu by performing the menu operation
below.
→
→
→
The Cursor Setting menu will appear.
Detail information about cursor operation and display can be set by changing the settings of
the menu items.
3.8.4.1 EBL/VRM Control Cursor
• The EBL/VRM Control Cursor is switched between Valid and Invalid.
• The trackball is provided as a standard device. If the trackball malfunctions, the
cursor can be moved by using the [EBL] dial and [VRM] dial.
• The cursor moves horizontally when [EBL] is operated, and moves vertically
when [VRM] is operated.
• To switch between EBL/VRM operation and cursor operation while ON is
selected, hold down the [EBL] dial for 2 seconds.
3.8.4.2 Cursor Length
• Set the length of the cross cursor mark on the radar display.
: Cursor is operated using a [EBL] [VRM] dial.
: Cursor is operated using a trackball.
Cuts the cross cursor mark in length.
: Makes the cross cursor mark twice as long as when
Short is selected.
To Next Page
Loading...
