SETTINGS FOR SYSTEM OPERATION
7.1 SETTINGS AT INSTALLATION .............................................................7-1
7.1.1 How to Open the Serviceman Menuļ¼Service Man Menuļ¼ .........7-1
7.1.2 GYRO I/F Setting .............................................................................7-2
7.1.3 Tuning (Tune Adjustment) .............................................................7-5
7.1.4 Bearing Adjustment ........................................................................7-5
7.1.5 Range Adjustment ...........................................................................7-5
7.1.6 Navigator Setting (Device) .............................................................7-6
7.1.7 Setting of True Bearing Value ........................................................7-7
7.1.8 Antenna Height Setting (Antenna Height) .....................................7-7
7.1.9 Setting of CCRP (CCRP Setting) ....................................................7-8
7.2 SETTINGS ............................................................................................7-11
7.2.1 Communication Port Setting (COM Port Setting) .......................7-11
7.2.2 Sector Blank Setting (Sector Blank) ............................................7-15
7.2.3 Setting of Bearing Pulses from Scanner Unit (Output Pulse) ...7-16
7.2.4 Slave Mode Setting (Master/Slave) ..............................................7-16
7.2.5 Language Setting (Language) ......................................................7-17
7.2.6 Date Time Setting ..........................................................................7-18
SECTION 7
SETTINGS FOR SYSTEM OPERATION
To Next Page
Loading...
Need help?
General
