JRC JMA-9172-SA - Section 4 Measurement of Range and Bearing; Use of Navigation Tools

MEASUREMENT OF RANGE AND BEARING
4.1 USE OF NAVIGATION TOOLS ..............................................................4-1
4.1.1 Using Cursor (Cursor) ....................................................................4-2
4.1.2 Using Range Rings (Range Rings) ................................................4-2
4.1.3 Using Electronic Bearing Line (EBL1/EBL2) ................................4-3
4.1.4 Using Parallel Index Lines (PI Menu) .............................................4-8
4.1.5 Operating EBL Maneuver Function (EBL Maneuver Setting) ....4-14
4.1.6 Operating EBL, VRM, and PI with Cursor ...................................4-16
4.2 MEASUREMENT OF RANGE AND BEARING ....................................4-19
4.2.1 Measurement with Cursor Position (Cursor) ..............................4-20
4.2.2 Measurement with Electronic Bearing Line and Variable Range
Marker [EBL] [VRM] .....................................................................4-20
4.2.3 Measurement with Two Arbitrary Points .....................................4-21
SECTION 4
MEASUREMENT OF RANGE AND
BEARING