JRC JMA-9172-SA - Set Radar Display (Display Setting)

JMA-9172-SA Instruction Manual > 3.BASIC OPERATION > 3.8 APPLIED OPERATIONS
3－101
3
3.8.4.3 Cursor Pattern
• The type of the cross cursor mark displayed of the display is selected.
3.8.5 Set Radar Display (Display Setting)
This system can save combinations of display color and brilliance in accordance
with ambient lighting conditions and the radar display can be easily switched.
Follow the procedures below to set display color and brilliance to be saved before
hand.
3.8.5.1 Setting display color (Display Color Setting)
Procedures
1) Open the Color Setting menu by performing the menu operation
below.
→
→
Display Color Setting menu will appear.
3.8.5.2 Day/Night
• Specify the mode to be changed.
• The following modes are available:
: Type 1 is selected for the cross cursor mark 1 displayed in the radar display.
: Type 2 is selected for the cross cursor mark 2 displayed in the radar display.
: Type 3 is selected for the cross cursor mark 3 displayed in the radar display.
: Type 4 is selected for the cross cursor mark 4 displayed in the radar display.
: Day mode 1 : Used under bright lighting conditions.
: Day mode 2 : Used under bright lighting conditions.
: Day mode 3 : Used under bright lighting conditions.
: Dusk mode : Used under dim lighting conditions.
Main
7. Sub Menu
1. Display Color Setting
Day1
Day2
Day3
Dusk