JMA-9172-SA Instruction Manual > 3.BASIC OPERATION > 3.8 APPLIED OPERATIONS
3－105
3
3.8.7.1 Initial Setting (Option Key Setting)
Set functions that can be performed with the option key switches.
1) Open the Option Key Setting menu by performing the menu
operation below.
→
→
The Option Key Setting menu will appear.
This system provides two user keys: [OPTION 1] and [OPTION 2]. Different functions can
be allocated to each key.
Functions that can be allocated to each key are as follows:
3.8.7.2 Using Option Keys (Directly displaying a specified )
Preset the that is to be displayed with the option key switch.
1) Perform the general menu open procedure to open the menu that
is to be directly displayed with Option Key.
2) While the menu is open, hold down [OPTION 1] key or [OPTION 2]
key for 2 seconds.
: A specific menu is directly displayed.
: The zoom display function is switched between on and off.
: Set/Cancel Waypoint menu key
: Start-point, Pass-point key in simple route operating
: End-point key in simple route operating
: Screen capture key (This function is enabled only when the
card (optional) is connected.)
To Next Page
Loading...
