JRC JMA-9172-SA - Page 84

2－24
JMA-9172-SA Instruction Manual > 2.CONTROL PANEL KEYS and SOFTWARE BUTTONS > 2.3 FUNCTIONS OF SOFTWARE
BUTTONS
Manual own ship's speed setting
When selection of the speed sensor is set to , enter the own ship's speed
manually.
If this button is clicked, the numeric value input screen is opened. After setting a value,
determine the entry by clicking .
Target tracking (TT) / AIS information
Target vector display true / relative switching
The tracked target / AIS target vector display is switched to (true vector) /
(relative vector) whenever this button is clicked.
This setting is switched together with the past position display true / relative switching.
Target vector length setting
Set a vector length of the tracked target / AIS target.
If this button is clicked, the numeric value input screen is opened. After setting the
length, determine the setting by clicking .
CPA limit setting
Set a CPA limit.
If this button is clicked, the numeric value input screen is opened. After setting the limit,
determine the setting by clicking .
TCPA limit setting
Set a TCPA limit.
If this button is clicked, the numeric value input screen is opened. After setting the limit,
determine the setting by clicking .
4
MAN
ENT
⑥ Past position display
interval switching
⑪ Association
On / Off
⑭ Radar trails display time
switching
⑬ Radar trails display
true / relative switching
① Target vector display
true / relative switching
② Target vector length setting
⑤ Past position display
true / relative switching ⑦ Past position display
interval unit switching
④ TCPA limit setting
③ CPA limit setting
⑧ AIS
On / Off
⑩ AIS target symbol display
On / Off
⑨ Tracked target symbol
display On / Off
⑫ AIS filter mode switching
1
T
R
2
ENT
3
ENT
4
ENT