7-35
[III] Save of Antenna Time (TXRX to Display Unit)
This procedure is to save the antenna time data.
When the antenna's internal control circuit is replaced, perform the following procedure to inherit the antenna
time data:
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the TXRX to Display
Unit menu.
Maintenance Menu
→ TXRX Time
→ TXRX to Display Unit
3. Select Yes in the Confirmation Menu.
The antenna time data in the antenna's internal control circuit is saved to the
display unit.
[IV] Reading of Antenna Time (Display Unit To TXRX)
This procedure is to read the antenna time data.
When the antenna's internal control circuit is replaced, perform the following procedure to read the antenna
time data
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the Display Unit to
TXRX menu.
Maintenance Menu
→ TXRX Time
→ TXRX to Display Unit
3. Select Yes in the Confirmation Menu.
The antenna time data in the display unit is sent to the antenna's internal control circuit.
To Next Page
Loading...
Need help?
General
