2-23
Own ship's information
①：Speed sensor switching
The speed sensor is switched whenever the button is clicked.
MAN (Manual) ⇒ LOG (Single-axis water log) ⇒ 2AXW (Dual-axis water log)
⇒ 2AXG (Dual-axis ground log) ⇒ GPS ⇒ MAN
When the selected speed device is not connected to the equipment, an alarm is issued.
※ If the reception error occurs when 2AXG is selected, it automatically changes into 2AXW four seconds
after the error occurrences.
※ If current correction (Set/Drift Setting) is set while the AIS function is used, LOG or 2AXW cannot be
selected.
※ When the AIS function is used, MAN cannot be selected.
See section 5.3.1.
②：Time display mode switching
The time display mode UTC (universal time clock) / LMT (local mean time) is switched whenever
this button is clicked.
③：Manual own ship's speed setting
When selection of the speed sensor is set to MAN , enter the own ship's speed manually.
When the button is clicked, the numeric value input screen is opened. After setting a value, determine the
entry by clicking ENT .
To Next Page
Loading...
