INSTALLATIONS
2-6
2.2.1.2 Installation
(1) Bottom part and upper part (wiring)
The MF/HF transceiver has a bottom part and an upper part, refer to the following procedure to install
them. Refer to the information on wiring the electric cables and signal lines described later also.
Note 1: Install the upper part after wiring the power cables and signal lines.
Note 2: Refer to the following pages for information on installing the extension board
(CQD-2416) in the bottom part.
Screw
2. Rotate the top plate in the direction of the arrow and remove it.
Top plate
Cover
1. Loosen the 6 screws (M4), and remove the cover.
To Next Page
Loading...
