JRC JSS-2150 - Connecting the Signal Lines

INSTALLATIONS
2-62
2.2.9.3 Connecting the signal lines
• Back of NKG-91 main unit
Serial connector
• Back of MF/HF controller (NCM-2150)
Remove the serial connector cover and the cover
over the printer power source. Then connect the
printer connection cable and the printer power cable.
After connecting the power cable, fix it with the cable
clamp and replace the cover over the printer power
source.
Note) When the NKG-91 is installed, set the
printer power supply to 6.5V (factory
default). For details of the printer power
supply setting, see the NKG-800 section.
No. Signal name Direction Functions
1 DC + Input
DC +
power source
2 DC - Input
DC -
power source
3 E － Ground
Printer power cable:
DPYC-1.5
or
MVVS-20/0.18*2-6.5P-(8)
Printer cable:
7ZCJD0254A
(1.5 m)
Connector terminal wiring example for power source
Serial connector cover
Printer power cover
Cable clamp
赤黒緑
321
Power connector
(
6.5 V
)
Green Black Red
DC 6.5 V
max. 2 A
(for printer)