INSTALLATIONS
2-30
2.2.3.2 Building the connector for the handset
Step 5. * Insert the lock nut (8) into the housing terminal.
*
The solder cable (6) is
divided to contact positions in the housing
* Insert the O-ring (7) onto the front end of the housing.
Step 1. Stripping
Step 2. Insert seal (4) into the back half of the clamp ring (3).
Step 3. Insert gasket (2) into the front half of the clamp ring (4).
Step 4. Insert the stripped cable into the sealing nut (2) and the clamp
ring (2).
Caution: 1. Ass'y tool (cap) can be substituted as the mating connector.
2. Ass'y hand tools (cap & wrench) must be purchased separately.
Step 6. Screw the front of clamp ring (3) all the way onto the end of the
housing (1).
Step 7. Screw sealing nut (5) onto the end of the clamp ring (3).
Tighten by hand or with a tool.
To Next Page
Loading...
