INSTALLATIONS
2-19
2.2.1.4 Connecting the signal lines
Connect the signal line to terminal TB11 - 14 on the terminal board (CQD-2415) or to terminal TB21 -
23 on the extension board (CQD-2416) as described below.
① Slide a thin flathead screwdriver all the way into the
slit as shown in the figure to the right and then insert
the signal line*.
*) Compatible wire sizes: 0.2 - 2.5 mm
2
(AWG 24~12)
Stripped length: 8 mm
② Remove the screwdriver and make sure that the
signal line is securely connected.
③ When the wiring is finished, secure the cables in a
bundle with the cable clamp. For more details, see
2.2.1.2 Installation.
信号線挿入口
スリット
マイナスドライバ
Slit
Flat-head screw driver
Signal line port
To Next Page
Loading...
