JRC JSS-2150 - Setting the AC Input Voltage (110 VAC;220 VAC)

INSTALLATIONS
2-50
2.2.8.3 Setting the AC input voltage (110 VAC/220 VAC)
Open the cover on the back panel indicated by the arrow in the drawing and use the short plug to
switch the AC input voltage according to the setup manual provided. The factory setting is 220 VAC.
After setting the AC input voltage, remove the appropriate label for the input voltage from the voltage
switching tag ((1) on the following page) and stick it in the box on the voltage label ((2) on the following
page).
Terminal block