JTECH Medical COMMANDER ECHO - Commander Echo Console; Instructions for Registering a New Instrument; Instructions for Deleting a Registered Instrument; Instructions for Changing the RF Channel

© 2017 JTECH Medical MN022_M
18
Registering a New Instrument For Use With Your Commander Echo Console
The Commander Echo Console comes with all instruments pre-registered for use; however, should you
purchase a new instrument at a later me, the following instrucons can be used to add or remove a
instrument. If you need addional help registering new instruments with the Console, contact customer
service.
Instructions for registering a new instrument
1. Select “Sengs” from the main menu.
2. Highlight “System.”
3. Press le/right unl “Register” is displayed.
4. Turn on the instrument followed by pressing the Control Sck.
5. If the Console successfully registers the instrument then the Console will return to the sengs screen.
Otherwise, once the instrument turns o, turn the instrument back on to try again.
6. To exit the registraon without registering a instrument, hold le for 2 seconds.
Instructions for deleting a registered instrument
1. Select “Sengs” from the main menu.
2. Select “Instrument.”
3. Select the instrument type for the instrument ID you wish to delete and press the Control Sck.
4. Highlight “System.”
5. Press le/right unl “Info” is displayed, and press the Control Sck.
6. Press up/down unl the device ID that you wish to delete is displayed.
7. Hold the Control Sck unl the Console returns to the sengs screen.
Instructions for changing the RF channel
1. Select “Sengs” from the main menu.
2. Highlight “System.”
3. Press le/right unl “Scan” is displayed, and press the Control Sck.
4. Wait approximately 10 seconds, when the Console is nished it will have set the best channel found at the
me.
Instructions For Multiple Commander Echo Consoles
1. Aer turning on a Console enter the “Test” menu to connect any instrument.
2. Next turn on an addional Console then follow the instrucons for “changing the RF channel.
3. Connect to an instrument.
4. Repeat as necessary for each addional system
This will insure that each Console does not interfere with any other Console at your locaon. A total of 12
systems can be setup to operate without interfering with each other. The 12 system limit does not account
for possible interference from wireless systems other than Commander Echo.
Displaying Instrument Battery Voltage
1. Select “Sengs” from the main menu.
2. Select “Instrument.”
3. Select the instrument type for the instrument ID you wish to display baery voltage.
4. Highlight “System.”
5. Press le/right unl “Info” is displayed, and press the Control Sck.
6. The Console will now aempt to connect to the selected instrument. Press the “On” buon for the
corresponding instrument followed by pressing the Control Sck on the Console to establish connecon.
7. Once connected the Console LCD will show the instrument’s serial number, revision, baery voltage and
calibraon informaon.