JTECH Medical COMMANDER ECHO - Page 24

© 2017 JTECH Medical MN022_M
22
Stac Tesng Mode
Each individual rep is zeroed by pressing the Enter buon at the beginning of the rep and ended by pressing
the Enter buon at the end of the repeon.
Stac tesng can be performed using either single or dual inclinometry protocols. Stac tesng means the
paent’s range of moon is measured in a stac posion. In Stac Tesng Mode, ROM is also only measured
for a single joint movement, such as single inclinometry elbow exion or dual inclinometry thoracic kyphosis.
To perform stac tests you must change into Stac Tesng Mode.
Dynamic Tesng Mode
Each TEST is zeroed on the rst repeon. Aer being zeroed on the rst rep, each rep is ended by pressing the
Enter buon again. This is similar to Stac Tesng Mode except that there is only one zero (at the beginning of
rep 1).
Using dual inclinometry in Dynamic Tesng Mode is the preferred method for measuring most spine ranges of
moon. Dynamic Tesng Mode measures movement pairs, such as cervical exion/extension, or le and right
cervical lateral exion. To perform Dynamic tests you must change into Dynamic Tesng Mode.
Dynamic tests can be performed using dual or single inclinometry. For dual inclinometry, the display provides
three measurements: movement of both sensors and Total Range of Moon. For single inclinometry, the
display only shows the Primary device’s movement. Dynamic Tesng Mode for dual or single inclinometry is
essenally the same.
Auto-rep mode:
Each TEST is zeroed on the rst repeon. Aer being zeroed on the rst rep, the inclinometer moves to some
max angle (greater than 10 degrees from zero), and then returns to within 10 degrees of the zero posion. The
maximum angle will automacally be stored and the next rep will start.