－
9
－
When tilting the sewing machine head, tilt the
head gently until it comes in contact with head
support rod
❶
.
3-8. Tilting the sewing machine head
1. Before tilting the sewing machine
head, make sure that head support rod
❶
is attached to the machine table.
2. When the sewing machine head is tilt-
ed, feeding frame
❷
moves to the left
side by itself and interferes with the
intermediate presser or the like. As a
result, it will be the cause of breakage.
Remove the aforementioned component
in advance, or x feed plate
❸
to throat
plate support cover
❹
with tape or the
like, and tilt the sewing machine head.
3-9. Installing the operation panel
In the case of installing the operation panel on
the undersurface of the table, install the operation
panel on panel mounting plate
❶
by tightening
screws
❹
in four mounting holes. Then, x the
panel mounting plate at a desired position on the
undersurface of the table with four wood screws
❷
.
Fix operation panel mounting plate
❶
on the table
with four wood screws
❷
. Then, pass the cable
through hole
❸
in the table.
WARNING :
Tilt/raise the sewing machine head with both hands taking care not to allow your ngers to be caught
in the head. Turn OFF the power before starting the work so as to prevent accidents caused by abrupt
start of the sewing machine.
3. When tilting the sewing machine head while holding motor cover
❺
and throat plate support
cover
❹
, the covers may be bent. Be sure to tilt the sewing machine head while holding the
main unit of the sewing machine.
4.
Be sure to tilt the sewing machine head on a at place to prevent it from falling.
❶
❷
❸
❶
❹
❷
❶
❺
❷
❹
❸
To Next Page
Loading...
