JUKI LK-1920 - Error list

－
58
－
Error
code
Indication Description of error Corrective measure Remarks
E007
Machine lock error
The main shaft of the sewing machine does
not rotate due to some troubles.
Turn OFF the power switch and
remove the cause of troubles.
E010
Pattern No. error
Back-uped pattern No. has not been
registered in the data ROM, or it is set to
readout inoperative.
Pattern No. is set to "0".
Press the reset key and check
the pattern No.
Check the contents of memory
switch No. 201.
E011
External media not inserted
USB thumb drive is not inserted.
Re-operation is enabled after
resetting.
E012
Read error
Data cannot be read from the USB thumb
drive.
Re-operation is enabled after
resetting.
E013
Write error
Data cannot be written on the USB thumb
drive.
Re-operation is enabled after
resetting.
E014
Write-protect
USB thumb drive is write-protected.
Re-operation is enabled after
resetting.
E015
Format error
USB thumb drive cannot be formatted.
Re-operation is enabled after
resetting.
E016
External media capacity over
Memory capacity of the USB thumb drive to
write pattern data is not sufcient.
Re-operation is enabled after
resetting.
E017
Machine memory capacity over
Memory capacity of the sewing machine to
write pattern data is not sufcient.
Re-operation is enabled after
resetting.
E019
File size over
The pattern data to be read from the USB
thumb drive is too large. (Max.: Approxi-
mately 20000 stitches)
Re-operation is enabled after
resetting.
E024
Pattern data size over
The pattern data to be written on the sewing
machine memory is too large. (Max.: Ap-
proximately 20000 stitches)
Re-operation is enabled after
resetting.
E030
Needle bar position error
Needle bar is not in the specied position.
Turn the hand pulley to return
the needle bar to its specied
position.
E031
Air pressure drop
Air pressure is dropped.
Supply air and reset the sewing
machine. Then, the operation
is enabled again.
9-3. Error list