JUKI LK-1920 - DRAWING OF THE TABLE

－
65
－
4 places on the rear side-table stand (Drill at the time of set-up)
Drawer stopper installing position (one place on the rear side)
2 (all corners)
2 (all corners)
Power switch installing position - 2 places on the rear side (Drill at the time of set-up)
4- drilled hole 2, 10 deep
Drilled hole 28
4- drilled hole 7, 14 spot face 7.5 deep
3- drilled hole 2, 10 deep
Oil-drain funnel installing hole (Drill at the time of set-up)
Drilled hole 30, 51 spot face 16 deep
5-drilled hole 8
Drilled hole 16
Right side
Drilled hole 17
1200
1130
199 810
964
700
200
527
93
438
20
5021
8
38
54.5
182170
488
1040
40
10
139.5
257
R2
6
10
398.5
390
286
14.5
42
230
373
250.5
570
70
280
23.4
53.6
77
8
14
500
432
180
R2
R30
R30
R30
R30
4-R10
R10
R10
Ø38
115
13.5
133.5
35
133.4
146.9
62
71
197.5
313.5
25
85
184
Pedal switch installing hole - 2 places on the reverse side (Drill at the time of set-up)
Manual pedal chain inserting hole
360
110
75
230
10. DRAWING OF THE TABLE