－
33
－
❻ ❼
❾
(2) Method of editing cycle data
1) Set the mode to input mode
Under the input mode where SET READY
LED
goes out, entry of the cycle data is
enabled.
If the current mode is the sewing mode, press
READY key
❷
to change over the
mode to the input mode.
2) Set cycle data to editing status
When EDIT key
❽
is pressed, the cycle
data editing display
C
appears on the screen.
The pattern No.
D
to be sewn is displayed in
reverse video.
In this state, it is possible to edit the data.
3) Selecting the edit point
When you press ITEM SELECT key
❻
, the edit point is changed and the current point is
displayed in reverse video. When you move the edit point forward until the last point is reached,
additional indication pictograph is displayed.
When you press EDIT key
❽
while selecting the edit point, the additional indication picto-
graph is displayed at the selected position to enable insertion of pattern data.
4) Change data of selected editing point
Press DATA CHANGE key
❼
and data of editing point can be changed.
Pattern No. which has been registered is displayed and it is possible to select.
In addition, press RESET key
❸
, and the pattern data of editing point can be deleted.
When RESET key
❸
is held pressed for one second, all the registered pattern data can be
deleted.
Repeat steps
3)
and
4)
to perform editing data.
5) Cancelling insertion of pattern data
Insertion of the pattern data is cancelled and the mode is changed over to the input mode by pressing
RETURN key
❾
.
C D
❽
❷ ❸
To Next Page
Loading...
