JUKI LK-1920 - Page 55

－
53
－
No. Function Setting range
State when
delivered
Remarks
U051
Wiper control can be prohibited
: Wiper output prohibited
: Wiper output enabled
-
U071
Thread breakage detection selection
: Prohibited : Enabled
-
U072
Number of invalid stitches at the start of sewing of
thread breakage detection
0 to 15 8
U073
Number of invalid stitches during sewing of thread
breakage detection
0 to 15 3
U074
The fan operation can be set
: Energy saving mode
: Constantly operates
-
U075
With/without air pressure detection
: Without : With
- For the LK-1910A
and LK-1920A, the air
presser detection can
be set to .
U105
Intermediate presser : wiper sweeping position
: Upper wiping : Lower wiping
* Displayed only for the LK-1920
-
U129
With/without needle cooler control
: Without : With
-
U132
Selection of the tension controller No. 3 mode
: Inversion shaft
: Tension controller No. 3
- When the inversion pat-
tern is used, the inver-
sion-specic operation
is prohibited by means
of the inversion output.
U133
Selection of the return-to-origin route for the inversion pattern
: Reverse trace prohibited
: Reverse trace enabled
-
U134
With/without disc oating device control
: Without : With
-