– 36 –
A : Number of stitches of normal stitching setting
0 to 15 (F) stitches
B : Number of stitches of reverse stitching setting
0 to 15 (F) stitches
C : Number of stitches of normal stitching setting
0 to 15 (F) stitches
D : Number of times of repetition
0 to 9 times
(Caution) When process D is set to 5 times, the sew-
ing is repeated as A → B →C → B → C.
[Setting procedure of the overlapped stitching]
1. Hold pressing / switch , and press /
switch to select the overlapped stitching pat-
tern.
(Every time / switch is pressed, reverse
stitching pattern/overlapped stitching pattern change
over alternately.)
2. The number of stitches for process A becomes in
flashing state.
3. Every time / switch is pressed, the flashing
position shifts in the right direction and the display of
the process where setting can be changed flashes
on and off.
4. Press switch or switch to change the
number of stitches.
5. When the setting of all processes has been com-
pleted, press / switch to determine the
contents of the setting. (Flashing stops.)
(Caution) When the overlapped stitching is selected,
the automatic operation display flashes on
and off. It is not possible to release the
automatic operation.
5. Press / switch to make number of
stitches display flash on and off, and set the num-
ber of stitches for the respective processes of the
stitching.
6. Press switch or switch to change the
number of stitches.
The number of stitches can be changed up to as
many as 15 stitches for the A, B, C, and D processes
respectively.
However, displays are as follows.
10 stitches = , 11 stitches = , 12 stitches = ,
13 stitches = , 14 stitches = and 15 stitches
= .
7. When the setting of all items has been completed,
press / switch to determine the contents
of the setting. (Flashing stops.)
LED lights Up.
LED lights Up.
2) Overlapped stitching pattern
Overlapped stitching patterns below can be set by using the operation panel.
Flash
Reverse stitching pattern
Overlapped stitching pattern
Flash
To Next Page
Loading...
Need help?
General
