JUKI SC-910N Engineer's Manual

– 35 –
3. Press switch or switch and select the
reverse stitching pattern.
Reverse stitching patterns and displays are as follows.
: Reverse stitching
:Double reverse stitching
: Without reverse stitching
4. Press / switch to make reverse stitching
at end display flash on and off, and set the pat-
tern in the same way as step 3.
2. Press / switch to make reverse stitching
at start display flash on and off.
Every time / switch is pressed, the
flashing position shift in the right direction.
(Caution)The sewing machine does not start in the
flashing state.
[Setting procedure of the reverse stitching]
1. Hold pressing / switch , and press /
switch to select the reverse stitching pattern.
(Every time / switch is pressed, reverse
stitching pattern/overlapped stitching pattern change
over alternately.)
D
C
A
B
A
B
C
A
B
D
C
C
D
C
C
A
B
A
B
D
C
D
C
C
C
A
D
C
D
C
C
C
A
B
B
A
B
A
D
C
A
B
D
C
A
B
(4) Operating procedure of the sewing pattern
1) Reverse stitching pattern
Reverse stitching patterns below can be set by using the operation panel.
Reverse stitching patterns that can be set
Reverse stitching
at start display
Sewing pattern
Revers stitching
at end display
Reverse stitching pattern Overlapped stitching pattern
LED lights Up.
LED lights Up.
Flash
Shift direction
Flash
Contents of reverse
stitching selection
Updating with switch
Updating with switch

JUKI SC-910N Specifications

General

Brand	JUKI
Model	SC-910N
Category	Sewing Machine
Language	English