– 20 –
(3) Special setting
It is possible to change the set value in the front panel by directly moving to the function setting mode while
the power is turned ON in addition to the normal function setting procedure.
[ Moving procedure to the function setting mode ]
1) Hold pressing / switch
2
, and press
switch
4
to move to the function setting
mode.
(Caution) Function setting No. 2 is displayed im-
mediately after the changeover.
2) When returning to the normal mode, press /
switch
1
and determine the contents of the
setting.
1
Material end sensor function setting (Function
setting No. 2)
It is rendered effective when connecting the op-
tional material end sensor.
It is possible to change the set value with
switch
3
or switch
4
.
0 : Material end sensor function is prohib-
ited.
1 : Material end sensor function is effective.
When "1" is selected, material
end sensor display lights up
when the mode has returned to
the normal one.
2
Thread trimming operation after material end
stop setting (Function setting No. 3)
Press / switch
2
to advance to the func-
tion setting No. 3.
It is possible to change the set value with
switch
3
or switch
4
.
0 : Material end stop
1 : Automatic thread trimming after detec-
tion of material end
When "1" is selected, the auto-
matic thread trimming display
lights up when the mode is re-
turned to the normal one.
1 2 3 4
1 2 3 4
1 2 3 4
To Next Page
Loading...
Need help?
General
