JUKI SC-910N - Setting for functions of SC-910 N

– 22 –
4. Setting for functions of SC-910N
Functions can be selected and specied by means of the four setting switches and light emitting diode lo-
cated inside the front cover of the SC-910N.
1
Switch for enteringspeciedvaluechanged
and updating setting No. in DOWN direction
2
Switch for enteringspeciedvaluechanged
and updating setting No. in UP direction
3
Down switch (DOWN)
4
Up switch (UP)
(Caution) • Do not perform switch operations other than those described in the following explanations.
• Be sure to re-turn the power switch ON after one second or more has passed. If the
power is turned ON immediately after turning it OFF, the sewing machine may not
work normally. In this case, turn ON the power again.
WARNING :
To avoid possible personal injuries caused by movement other than that you desired, do not
operate the switches in the procedure other than those required, as described below, to specify the
functions.
Speciedvalue
SpeciedNo.
1 3 42
5
6
How to change over to the function setting mode
1) Turn OFF the power to the unit.
2) Pressing switch
4
, turn ON the power to the
unit.
3) Indication
5
and
6
will be shown on the screen
display.
(The indication item shows the item, the setting
of which was changed the last time.)
* If the indication fails to change, re-perform the
procedures 1) and 2).
4