– 33 –
ENGLISH
6 5
– 1 5
4
On-timing of solenoid for condensation stitch (when condensation stitch is performed by 1 stitch.)
(Function setting No. 65)
Starting timing of solenoid for condensation of 1 stitch can be corrected by angle at the unit of 10˚.
Adjusting range
– 36 to 0 <1 / 10˚>
5
On-timing of solenoid for condensation stitch (when condensation stitches are performed by 2 stitches
or more.) (Function setting No. 66)
Starting time of solenoid for condensation of 2 stitches or more can be corrected by angle at the unit of 10˚.
Adjusting range
– 36 to 0 <1 / 10˚>
6
Needle thread release function (Function setting No. 28)
This function sets the number of stitches until the clamped needle thread is held after the start of sewing
Setting range : 0 to 30 stitches
7
Thread draw-out/return solenoid (Function setting No. 89)
This function sets whether the motion of draw-out/return solenoid (LZ) is performed or prohibited.
0 : Motion is ineffective.
1 : Function is effective.
8
Number of stitches of tension release motion at the sewing start (Function setting No. 100)
This function sets the number of stitches to make the tension release solenoid actuate at the sewing start.
Setting range : 0 to 9 stitches
2 6
0
2 7
5 0
2 5
1
2 2
0
2 1
0
1 0 0
0
8 9
0
2 8
1
6 6
– 1 5
!1
Neutral automatic presser lifting function (with AK device only) (Functionsetting No. 21)
This function can automatically lift the presser foot when the pedal is in the neutral position.
Automatic lifting time of the pedal depends on the automatic lifting time after thread trimming and when
the presser foot is automatically lowered, it is automatically lifted at the second neutral position after it has
come off the neutral position once.
0 : off Function of neutral automatic presser lifting is not operative.
1 : on Selection of function of neutral automatic presser lifting
!2
Function of changeover of compensating switch on the operation panel function (Function setting No. 22)
Function of compensation switch on the operation panel of CP-170 or IP-110 can be changed over to nee-
dle up / down compensating stitching or one stitch compensating stitching.
0 : Needle up / down compensating stitching
1 : One stitch compensating stitching
!3
Thread trimming motion condition (Function setting No. 25)
This function makes the thread trimming motion ineffective when depressing the back part of the pedal af-
ter DOWN detection position has been off by turning handwheel by hand or the like.
0 : Thread trimming motion is effective.
1 : Thread trimming motion is prohibited.
!4
Function of setting the holding force after stop (Function setting No. 26)
Function to prevent the increased amount of reverse rotation after stop when the machine has been used for
a long time and the machine head torque has become light. When the set value is increased, the prevention
effect becomes large. However, when the set value is excessively increased, on the contrary, there is a dan-
ger that the machine normally rotates. Adjust the function while checking the motion of the needle bar.
Setting range : 0 to 9
!5
Function of setting the reaction force at the time of retry (Function setting No. 27)
This function changes the magnitude of the reversing force before moving to the retry motion.
Setting range : 1 to 100
1 : Less reversing force to 100 : More reversing force
To Next Page
Loading...
