32
9 Adjustment options
9.1 The level concept
Two levels In order to make the operation of the pressure transmitter simple and transpar-
ant, the functions of the JUMO dTRANS p02 have been divided into two lev-
els.
Both levels can be accessed from the keypad of the transmitter.
Display level In normal operation, the instrument is in the display level.
The display options are: pressure, measurement, output current, sensor tem-
perature or peak-reading pointer. Step through with the or keys.
Parameter
level
At this level, the parameters that can be checked or altered include the follow-
ing: measurement start, measurement end, zero, dimensional unit, damping
and output current in a fault situation.
The keypad can be found underneath the cover flap of the pres-
sure transmitter.
➩
"Open cover flap", page 14.
As an alternative to operation from the keys, all the measured val-
ues and parameters can be easily displayed and/or set up using
the setup program. The setup program is available on request, at
extra cost
➩
"Setup program", page 7.
After applying the supply voltage, and after the end of the self-test,
the instrument is in the display level. The display that was most
recently selected will be shown (for new instruments ex-works, this
is “Pressure with unit”).
To Next Page
