To Next Page

To Previous Page

0999.GB

C 2

3 Wheel arm adjustment

The distance between the wheel arms is adjustable (refer to chapter B).

Adjusting the wheel arms must only be carried out be trained service personnel.

4 Moving the truck without own drive

This type of operation is prohibited on slopes and inclinations.

If the truck must still be moved after a fault has occurred, proceed as follows:

– Set master switch to "OFF" position.

– Set key switch to "0" position and re-

move the key.

– Secure the truck against rolling away.

– Open and remove front hood

(see chapter F).

– Turn the screws (2) anticlockwise until

you reach the limit stop.

The solenoid brake is triggered. The

truck can now no longer be moved.

If you reached the target location, reset

the brake system to its original condition! The truck must not be parked with released

brake!

– Return the screws (2) anticlockwise until they touch the limit stop.

The original brake condition is restored.