F 11
0999.GB
6.8 Recommissioning the truck
Recommissioning of the truck following the performance of cleaning or maintenance
work is permitted only after the following operations have been performed:
– Check the horn for proper functioning.
– Check the main switch (Emergency-STOP) for correct function.
– Check the brake for correct function.
7 Taking the floor conveyor out of service
If the floor conveyor is to be taken out of service for more than two months, it must be
parked in a frost-free and dry location and all required measures are to be taken be-
fore, during and following decommisioning.
m
During decommissioning the truck must be jacked up ensuring that the wheels are
clear of the ground. Only this measure will ensure that wheels and wheel bearings do
not suffer damage.
If the floor conveyor is to be taken out of service for periods exceeding six months,
the service of the manufacturer must be contacted for further measures to be taken.
7.9 Operations to be performed prior to decommissioning
– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and refill, if required (see section 6.4).
– Apply a thin film of oil or grease to all parts not protected by a paint coating.
– Grease the truck as detailed in the lubrication chart (see section 5).
– Recharge the battery (see chapter D).
– Disconnect and clean the battery. Apply pole grease to the battery terminals.
A
In addition to this, all instructions as given by the battery supplier have to be obser-
ved.
– Spray all exposed electrical contacts with a suitable contact spray.
7.10 Measures to be taken during decommissioning
Every 2 months:
– Recharge the battery (see chapter D).
m
For battery-driven trucks:
Regular recharging of the battery is very important. Otherwise, excessive depletion
of the battery would occur caused by self-discharging, which will result in the destruc-
tion of the battery caused by sulfatisation.
F 11
0999.GB
6.8 Recommissioning the truck
Recommissioning of the truck following the performance of cleaning or maintenance
work is permitted only after the following operations have been performed:
– Check the horn for proper functioning.
– Check the main switch (Emergency-STOP) for correct function.
– Check the brake for correct function.
7 Taking the floor conveyor out of service
If the floor conveyor is to be taken out of service for more than two months, it must be
parked in a frost-free and dry location and all required measures are to be taken be-
fore, during and following decommisioning.
m
During decommissioning the truck must be jacked up ensuring that the wheels are
clear of the ground. Only this measure will ensure that wheels and wheel bearings do
not suffer damage.
If the floor conveyor is to be taken out of service for periods exceeding six months,
the service of the manufacturer must be contacted for further measures to be taken.
7.9 Operations to be performed prior to decommissioning
– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and refill, if required (see section 6.4).
– Apply a thin film of oil or grease to all parts not protected by a paint coating.
– Grease the truck as detailed in the lubrication chart (see section 5).
– Recharge the battery (see chapter D).
– Disconnect and clean the battery. Apply pole grease to the battery terminals.
A
In addition to this, all instructions as given by the battery supplier have to be obser-
ved.
– Spray all exposed electrical contacts with a suitable contact spray.
7.10 Measures to be taken during decommissioning
Every 2 months:
– Recharge the battery (see chapter D).
m
For battery-driven trucks:
Regular recharging of the battery is very important. Otherwise, excessive depletion
of the battery would occur caused by self-discharging, which will result in the destruc-
tion of the battery caused by sulfatisation.
To Next Page
Loading...
Need help?
General
