To Next Page

To Previous Page

0999.GB

E 10

Emergency lowering system

The emergency lowering system may only be used if there are no persons within the

danger zone.

If the lifting device can no longer be lowered due to a defect in the lifting control sy-

stem, the emergency lowering system has to be activated.

– Set key switch (2) to its "0" position

and set the master switch (1) to its

"OFF" position.

– Pull the battery connector (see chap-

ter D).

– Open the front hood (see chapter F).

– Loosen the screw on the valve group

(13).

The required Allen key (2.5 mm) can be

found at the valve group.

The lifting device is lowered.

– Retighten the screw (13) after the

emergency lowering procedure has been performed.

The truck may only be retaken into service after the required troubleshooting measu-

res were successfully performed.

4.4 Safe parking of the truck

If the truck is left unattended, even for only short periods of time, it must be rendered

safe.

Do not park the truck on slopes! The lifting device must always be completely lowe-

red.

– Bring control shaft (4) into brake position (B).

– Lowering the lifting device.

– Set key switch (2) to "0" position and remove the key.

– Set master switch (1) to "OFF" position.