Jungheinrich EJB 16 - Putting Vehicle into Operation

0999.GB
E 4
3 Putting vehicle in operation
f
Before starting or operating the truck, or before lifting any loads, the driver has to
make sure that nobody is within the danger area.
Checks and actions before routine start-up
– Visual inspection for damages of the whole truck (especially tyres and load carrying
devices).
– Visual inspection of battery fixing and cable connections.
Starting up the truck
– Pull out master switch (1).
– Put key into the key switch (2) and turn right until stop to position "I".
The combined instrument (3) indicates the available battery capacity.
– Check function of horn (10).
– Check control shaft (4) for braking and driving function (see section 4.2).
The truck is now ready for operation.
0999.GB
E 4
3 Putting vehicle in operation
f
Before starting or operating the truck, or before lifting any loads, the driver has to
make sure that nobody is within the danger area.
Checks and actions before routine start-up
– Visual inspection for damages of the whole truck (especially tyres and load carrying
devices).
– Visual inspection of battery fixing and cable connections.
Starting up the truck
– Pull out master switch (1).
– Put key into the key switch (2) and turn right until stop to position "I".
The combined instrument (3) indicates the available battery capacity.
– Check function of horn (10).
– Check control shaft (4) for braking and driving function (see section 4.2).
The truck is now ready for operation.