Jungheinrich EKS 310 - Page 65

0206.GB
E 30
Dismantling the hydraulic brake
– Remove the electronic compartment cover at the back.
– Remove the protective cap (43) from the discharge valve.
– Push the hose (44) onto the vent connectino and insert the other end of the hose
in the brake fluid container (45) above it.
F
Brake fluid container is pressurised.
Risk of scalding.
– Open the discharge valve (42) and drain the brake fluid into the brake fluid
container.
– Close the discharge valve and brake fluid container.
Z
Switch on the truck and press the foot switch several times to restore the functionality
of the brake system.
M
Check the brake retardation.
0206.GB
E 30
Dismantling the hydraulic brake
– Remove the electronic compartment cover at the back.
– Remove the protective cap (43) from the discharge valve.
– Push the hose (44) onto the vent connectino and insert the other end of the hose
in the brake fluid container (45) above it.
F
Brake fluid container is pressurised.
Risk of scalding.
– Open the discharge valve (42) and drain the brake fluid into the brake fluid
container.
– Close the discharge valve and brake fluid container.
Z
Switch on the truck and press the foot switch several times to restore the functionality
of the brake system.
M
Check the brake retardation.