0708.GB
F 6
e) IG: inductive guidance trucks
Maintenance intervals
Standard = t WA BC
Lift
mechanism:
10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Warning: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains t
10.5 Visually inspect rollers, slide pieces and stops t
Attachments: 11.1 Test operation and settings t
11.2 Check attachment on truck and load bearing items t
11.3 Check forks and fork carriage for wear and damage t
11.4 Lubricate fork carriage rollers t
Lubrication: 12.1 Lubricate the truck according to the lubrication schedule t
General mea-
surements:
13.1 Check electrical system for accidental earth t
13.2 Check travel speed and braking distance t
13.3 Check lift and lowering speeds t
13.4 Check safety devices and cutouts t
13.5 IG: Measure the current in the guidance wire, adjust if
necessary e)
t
13.6 Check travel on the IG wire, check maximum deviation
and adjust if necessary e)
t
13.7 Check tracking mode on the IG wire for aisle tracking
.e)
t
13.8 Check IG EMERGENCY STOP operation e) t
Demons-
tration:
14.1 Test run with rated load t
14.2 When maintenance is completed, present the truck to
the responsible person.
t
0708.GB
F 6
e) IG: inductive guidance trucks
Maintenance intervals
Standard = t WA BC
Lift
mechanism:
10.1 Clean rollers, guide rollers and contact surfaces in the
mast sections and apply grease.
M
Warning: Danger of crashing!
t
10.2 Check mast attachments (bearings and retaining
screws)
t
10.3 Check lift chains and chain guide for wear, adjust and
lubricate
t
10.4 Lubricate lift chains t
10.5 Visually inspect rollers, slide pieces and stops t
Attachments: 11.1 Test operation and settings t
11.2 Check attachment on truck and load bearing items t
11.3 Check forks and fork carriage for wear and damage t
11.4 Lubricate fork carriage rollers t
Lubrication: 12.1 Lubricate the truck according to the lubrication schedule t
General mea-
surements:
13.1 Check electrical system for accidental earth t
13.2 Check travel speed and braking distance t
13.3 Check lift and lowering speeds t
13.4 Check safety devices and cutouts t
13.5 IG: Measure the current in the guidance wire, adjust if
necessary e)
t
13.6 Check travel on the IG wire, check maximum deviation
and adjust if necessary e)
t
13.7 Check tracking mode on the IG wire for aisle tracking
.e)
t
13.8 Check IG EMERGENCY STOP operation e) t
Demons-
tration:
14.1 Test run with rated load t
14.2 When maintenance is completed, present the truck to
the responsible person.
t
To Next Page
Loading...
Need help?
General
