Juniper E Series User Manual

E-series Hardware Guide
132 ! I/O Module Specifications
FE
FE-2
I/O
Non-ASIC ERX-7xx models
ERX-1410 router
SRP-5G
SRP-5G+
SRP-10G
2RJ-45
! For 10-Mbps operation, use
CAT 3, 4, or 5 UTP cable.
! For 100-Mbps operation, use
only CAT 5 UTP cable.
! The transmitted signal
complies with IEEE
802.3/802.3u for cable
lengths up to 100 m
(328 feet).
FE-8
I/O
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
8RJ-45
! For 10-Mbps operation, use
CAT 3, 4, or 5 UTP cable.
! For 100-Mbps operation, use
only CAT 5 UTP cable.
! The transmitted signal
complies with IEEE
802.3/802.3u for cable
lengths up to 100 m
(328 feet).
GE
GE
I/O
SFP
b,c
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
1 active
1 redundant
LC full duplex
! Tx power:
! min: –9.5 dBm
! max: –4 dBm
! Center wavelength: 850 nm
! Rx input power:
! min: –17 dBm
! max: –3 dBm
! Rated for 275 m (300 yards)
over 62.5-micron core cable
! Rated for 550 m (601 yards)
over 50-micron core cable
GE
I/O
SFP
b,d
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
1 active
1 redundant
LC full duplex
! Tx power:
! min: –9.5 dBm
! max: –3 dBm
! Center wavelength: 1300 nm
! Rx input power:
! min: –20 dBm
! max: –3 dBm
! Rated for 10 km (6.2 miles)
over 10-micron core cable
Table 22: I/O module specifications (continued)
I/O Module
Label
a
Type
Model
Compatibility
SRP Module
Compatibility No. of Ports
Connector
Type Cabling Specifications

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English