Configuring Line Module Redundancy ! 53
Chapter 5: Installing Modules
Verifying the Installation
To verify that the installation is complete:
1. After you have cabled the system for power (see Chapter 6, Cabling E-series
Routers), turn on the power switches.
The system reboots.
2. Issue the show redundancy command, and verify that the display shows the
redundancy hardware.
Configuring Line Module Redundancy
For information about configuring line module redundancy, refer to JUNOSe System
Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP Modules.
The Next Step
After you install the modules, you can connect cables to the system. Turn to
Chapter 6, Cabling E-series Routers.
To Next Page
Loading...
Need help?
General
