Juniper E Series User Manual

OCx/STMx POS and OC48 Modules ! 153
Chapter 13: Protocol Support
OCx/STMx POS and OC48 Modules
RIP Yes Yes
SMDS (trunk encapsulation) No No
Subscriber interfaces (static) Yes (over bridged Ethernet and IPoA) Yes (over bridged Ethernet and IPoA)
Subscriber interfaces (dynamic) Yes (over bridged Ethernet) Yes (over bridged Ethernet)
Transparent bridging Yes Yes
VRRP No No
Table 29: OCx/STMx ATM modules (continued)
Protocol or Application
OCx/STMx ATM Line Modules
with OC3-4 I/O Modules
OCx/STMx ATM Line Modules
with OC12/STM4 I/O Modules
Table 30: OCx/STMx POS and OC48 modules
Protocol or Application
OCx/STMx POS Line
Modules with OC3-4 I/O
Modules
OCx/STMx POS Line
Modules with OC12/STM4
I/O Modules
OC48 Line Module with
OC48 Frame APS I/O
Module
Acceptance of traffic for IP
tunnels
Yes Yes Yes
APS/MSP No Yes No
AT M N o N o N o
BERT No No No
BGP Yes Yes Yes
Bridged Ethernet Yes Yes No
Bridged IP No No No
CBF No No No
Cisco HDLC Yes Yes Yes
DHCP local server No No No
Dynamic interfaces No No No
F4 OAM (ATM
Administration)
No No No
FDL (facilities data link) No No No
Frame Relay Yes Yes Yes
IP Yes Yes Yes
IP Multicasting Yes Yes Yes
IPSec No No Yes
IPv6 No No Yes (PPP only)
IS-IS Yes Yes Yes
LAC Support – access side No No No
LAC Support – peer side Yes Yes Yes
LNS Support – Internet side No No No
LNS Support – peer side Yes Yes Yes

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English