Juniper E Series - Task 1: Turn off All E-Series Router Power

Cabling the E-series Router for Power ! 63
Chapter 6: Cabling E-series Routers
Figure 31: ERX-14xx model, power input module
Task 1: Turn Off All E-series Router Power
Before starting, you must switch all E-series router power switches to OFF.
! To turn off the router, push each power switch to the OFF position.
|
ON
O
OFF
|
ON
O
OFF
Ground
Power A
leads
Power B
leads
THIS PRODUCT IS EQUIPPED WITH
TWO POWER FEEDS. DISCONNECT
BOTH FEEDS PRIOR TO SERVICE.
POWER A POWER B
POWER A POWER B
-48VDC -48VDCRTN RTN
-48VDC RTN -48VDC RTN
WARNING!
NO OPERATOR ACCESSIBLE
COMPONENTS. AUTHORIZED
SERVICE PERSONNEL ONLY.
!
Power input
module cover
|
ON
O
OFF
|
ON
O
OFF
WITH
NNECT
VICE.
POWER A POWER
POWER B
-48VDCTN RTN
TN -48VDC RTN
|
ON
O
OFF
|
ON
O
OFF
H
CT
POWER A POWER B
POWER B
-48VDC RTN
-48VDC RTN
ARNING!
O
OFF
PO
-48VDC
-48VDC
g013752