SNMP ! 81
Chapter 8: Accessing E-series Routers
4. Disable the password.
host1(config-line)#no login
5. Run Telnet from a host on the same Ethernet network as the system.
6. Enter the IP address of the system to open the Telnet session.
The User Exec prompt appears when the Telnet session to the system is
established.
host1>
7. Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
8. Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode, from which you can configure
the system. See JUNOSe System Basics Configuration Guide, Chapter 2, Command
Line Interface.
SNMP
The system supports Simple Network Management Protocol (SNMP), a standard
management protocol for IP networks. You can configure the system as an SNMP
agent.
As an SNMP agent, the system provides access to management information that it
maintains. See JUNOSe System Basics Configuration Guide, Chapter 3, Configuring
SNMP for information on SNMP. See JUNOSe Command Reference Guide A to M and
JUNOSe Command Reference Guide N to Z for the commands that are available for
configuring the system as an SNMP agent.
The Next Step
Turn to Chapter 9, Maintaining E-series Routers.
NOTE: In this example, you disabled the password requirement, but you can
choose to set a password instead. See the JUNOSe System Basics Configuration
Guide, Chapter 6, Passwords and Security for information on setting a password.
CAUTION: Do not change the IP address for the Ethernet interface that you are
using to communicate with the system. If you change the address, you will lose
the Telnet session.
To Next Page
Loading...
Need help?
General
