NOTE: After the configuration is committed, the connectivity between the PC and
the switch might be lost. To renew the connection, release and renew the IP address
by executing the appropriate commands on the management PC or by removing
and reinserting the Ethernet cable.
Related Topics ■ Connecting and Configuring an EX Series Switch (CLI Procedure) on page 107
■ Installing and Connecting an EX2200 Switch
■ Installing and Connecting an EX3200 or EX4200 Switch
■ Installing and Connecting an EX4500 Switch on page 63
■ Installing and Connecting an EX8208 Switch
■ Installing and Connecting an EX8216 Switch
112 ■ Connecting and Configuring an EX Series Switch (J-Web Procedure)
Complete Hardware Guide for EX4500 Ethernet Switches
To Next Page
Loading...
Need help?
General