Juniper EX4500 Series User Manual

Table 3: LCD Panel Menu Options in EX4500 Switches (continued)
DescriptionMenu
The Maintenance menu has the following options to configure and troubleshoot
the switch:
■
SYSTEM HALT?—Choose one of the following:
■
Press Enter to halt the switch. Press Enter again to confirm the halt.
■
Press Menu to go to the next option in the Maintenance menu.
■
SYSTEM REBOOT?—Choose one of the following:
■
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
■
Press Menu to go to the next option in the Maintenance menu.
■
LOAD RESCUE?—Choose one of the following:
■
Press Enter to roll back the switch to the previous valid configuration.
Press Enter again to confirm the rollback.
■
Press Menu to go to the next option in the Maintenance menu.
■
FACTORY DEFAULT?—Choose one of the following:
■
Press Enter to restore the switch to the factory default configuration.
Press Enter again to confirm the restoration. The LCD flashes a success
or failure message and returns to the Idle menu.
■
Press Menu to go to the next option in the Maintenance menu.
■
ENTER EZSETUP?—Choose one of the following:
■
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
EZSetup configures DHCP and enables the J-Web user interface on the
switch. The LCD flashes a success or failure message for approximately
10 seconds and returns to the Idle menu.
■
Press Menu to go to the next option in the Maintenance menu.
For information about EZSetup, see “Connecting and Configuring an EX
Series Switch (J-Web Procedure)” on page 109.
NOTE: You can use EZSetup only if the switch is in the factory default
configuration.
■
EXIT MAINT MENU?—Choose one of the following:
■
Press Enter to exit the Maintenance menu.
■
Press Menu to return to the SYSTEM HALT option.
You can disable the Maintenance menu or the options in the Maintenance menu
in the LCD panel. See Configuring the LCD Panel on EX Series Switches (CLI
Procedure).
MAINT (Maintenance Menu)
Related Topics ■ Front Panel of an EX4500 Switch on page 7
■ Field-Replaceable Units in EX4500 Switches on page 14
■ Connecting and Configuring an EX Series Switch (CLI Procedure) on page 107
■ Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 109
12 ■ LCD Panel in EX4500 Switches
Complete Hardware Guide for EX4500 Ethernet Switches

Juniper EX4500 Series Specifications

General

Brand	Juniper
Model	EX4500 Series
Category	Switch
Language	English